Short Stroke Linear Position Sensor

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information
Certificates

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit each customer's preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as shown below:

Factory set to any length from 10mm to 50mm in increments of 1mm. For example, if your application requires 3/4" (19 mm) measurement then Positek will manufacture the sensor specifically for this length. The calibration will be set up for 19 mm.

Z010

Output Signal: 0.5-9.5V dc
Supply Input Option: +24V dc nom. + 13-28V

Z420

Output Signal: 4-20mA (3 wire source)
Supply Input Option: +24V dc nom. + 13-28V

J

Connector - Hirschmann GD series Axial, IP65

L

Cable with M12 gland or short gland Axial, Gland IP67

Specified in cm after the L
e.g. L200 for 200cm cable

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.

N

Front flange mount

P

Body clamps

R

Spring loaded (extended)

T

Dome end on plunger

V

Non captive plunger

BX002

0.5 - 9.5 V dc Output version

BX003

4-20 mA Output version

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.