Internally Mounted Cylinder Sensor With External Electronics

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information
Certificates

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit each customer's preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as shown below:

Factory set to any length from 20mm to 600mm in increments of 1mm. For example, if your application requires 10" (254 mm) measurement then Positek will manufacture the sensor specifically for this length. The mechanical length and calibration will be set up for 254 mm.

Z010

Output Signal: 0.5-9.5V dc
Supply Input Option: +24V dc nom. + 13-28V

Z420

Output Signal: 4-20mA (3 wire source)
Supply Input Option: +24V dc nom. + 13-28V

J

Connector - Hirschmann GD series Axial, IP65

L

Cable with M12 gland Axial, Gland IP67

M

Cable with short gland Axial, Gland IP67

Specified in cm after the L or M
e.g. L200 for 200cm cable

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.

Y

The sensor can be supplied without access to the two trim pots (gain and offset) with the adjustment holes sealed.
Option code

T

Flanged

P

M18 Thread

V

Penny and Giles HLP100

W

Temposonics (M4 fixing)

X

Parker Hannifin Cylinder Version

BX002

0.5 - 9.5 V dc Output version

BX003

4-20 mA Output version

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.