Intrinsically Safe Industrial Rotary Sensor

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information
Certificates

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit each customer's preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as shown below:

Factory set to any angle from ±10° to ±80° in increments of 1°. For example, if your application requires 90° measurement then Positek will manufacture the sensor specifically for this angular range. The sensor will measure 90° however will still rotate through 360°.

Z010

Output Signal: 0.5-9.5V dc
Supply Input Option: +24V dc nom. + 13-28V

Z420

Output Signal: 4-20mA (3 wire source)
Supply Input Option: +24V dc nom. + 13-28V

J

Connector - Hirschmann GD series Axial, IP65

M

Cable with short gland Axial, Gland IP67

L

Cable with M12 gland Axial, Gland IP67

Specified in cm after the L or M
e.g. L200 for 200cm cable from axial cable gland

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require, up to a maximum of 15000cm.

[blank]

Flanged housing

P

Servo mount

BX002

0.5 - 9.5 V dc Output version

BX003

4-20 mA Output version

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.