LIPS 100 Linear-Cylinder Position Sensor

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit the customer's individual preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as below:

Factory set to any length from 20mm to 600mm in increments of 1mm. For example, if your application requires 10" (254 mm) measurement then Positek will manufacture the sensor specifically for this length.
The mechanical length and calibration will be set up for 254 mm.

A

Output Signal: 0.5V-4.5V dc ratiometric
Supply Input Option: +5V dc nom. ± 0.5V

G

Output Signal: 0.5V-4.5V dc
Supply Input Option: +24V dc nom. + 9-28V

B

Output Signal: ±5V dc
Supply Input Option: ±15V dc nom. ± 9-28V

C

Output Signal: 0.5-9.5V dc
Supply Input Option: +24V dc nom. + 13-28V

D

Output Signal: ±10V dc
Supply Input Option: ±15V dc nom. ± 13-28V

E

Output Signal: 4-20mA (2 wire)
Supply Input Option: +24V dc nom. + 18-28V

F

Output Signal: 4-20mA (3 wire sink)
Supply Input Option: +24V dc nom. + 13-28V

H

Output Signal: 4-20mA (3 wire source)
Supply Input Option: +24V dc nom. + 13-28V

J

Connector - Hirschmann GD series Axial, IP65

L

Cable with M12 gland Axial, Gland IP67

M

Cable with short gland Axial, Gland IP67

Specified in cm after the L or M
e.g. L200 for 200cm cable

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require.

Y

The sensor can be supplied without access to the two trim pots (gain and offset) with the adjustment holes sealed.

T

M18

N

M20

P

3/4" UNF

(see drawing TG24-11)

V

Penny and Giles HLP100

W

Temposonics (M4 fixing)

X

Parker Hannifin Cylinder Version

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.