LIPS 103 Short Stroke Position Sensor

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information
Case Study

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit the customer's individual preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as below:

Factory set to any length from 10mm to 50mm in increments of 1mm. For example, if your application requires 3/4" (19 mm) measurement then Positek will manufacture the sensor specifically for this length. The calibration will be set up for 19 mm.

A

Output Signal: 0.5V-4.5V dc ratiometric
Supply Input Option: +5V dc nom. ± 0.5V

G

Output Signal: 0.5V-4.5V dc
Supply Input Option: +24V dc nom. + 9-28V

B

Output Signal: ±5V dc
Supply Input Option: ±15V dc nom. ± 9-28V

C

Output Signal: 0.5-9.5V dc
Supply Input Option: +24V dc nom. + 13-28V

D

Output Signal: ±10V dc
Supply Input Option: ±15V dc nom. ± 13-28V

E

Output Signal: 4-20mA (2 wire)
Supply Input Option: +24V dc nom. + 18-28V

F

Output Signal: 4-20mA (3 wire sink)
Supply Input Option: +24V dc nom. + 13-28V

H

Output Signal: 4-20mA (3 wire source)
Supply Input Option: +24V dc nom. + 13-28V

J

Connector - Hirschmann GD series Axial, IP65

L

Cable with M12 gland or short gland Axial, Gland IP67

Specified in cm after the L
e.g. L200 for 200cm cable

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require.

N

Front flange mount

P

Body clamps

R

Spring loaded (extended)

T

Dome end on plunger

V

Non captive plunger

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.