RIPS 501 Miniature Rotary Sensor

Specifications
Options
Datasheet
Part Number Configurator
Outline Drawing
Installation Information
Case Study

Positek offers a range of options for its standard sensors. Each sensor is manufactured to suit the customer's individual preferences. If your requirement is outside the options given below, Positek can modify/ redesign a sensor to suit your specific requirement. Standard options are available as below:

Factory set to any angle from ±15° to ±70° in increments of 1°. For example, if your application requires 90° measurement then Positek will manufacture the sensor specifically for this angular range. The sensor will measure 90°, however it will still rotate through 360°.

A

Output Signal: 0.5V-4.5V dc ratiometric
Supply Input Option: +5V dc nom. ± 0.5V

L

Cable

U

Lid with solder pins

T

Lid with boot IP67

Specified in cm after the L
e.g. L200 for 200cm cable
(L0 for U option)

Cable length - The standard length of cable supplied with a Positek position sensor is 50cm although you can specify any length you require.

N

Plain shaft with flat

P

Tongue with spring clip

If you need a position sensor that is outside the scope of the above options to suit your installation requirement or specification, please see our Custom Products for details.